Skip to content
MountainsideFoam & Coating, Sacramento24/7 roof line(916) 963-8097

Move water away from the house

Gutter installation and repair in Sacramento, CA

Sagging, overflowing or leaking gutters dump water on fascia, siding and foundations, and the damage shows up as rot long before it shows as a drip.

Typical range$8.40 to $19.80
Pricedper linear ft
Phone lineOpen 24/7
Crew member hanging a continuous-run 5-inch K-style aluminum gutter on a one-story Sacramento ranch home with fresh fascia
Quick answer

Gutter work covers new continuous-run gutters, repairs, re-hanging, downspout upgrades and fascia fixes. K-style aluminum gutters are the common choice, with half-round used on some older and custom homes. Typical pricing runs 8.40 to 19.80 per linear ft installed, and most homes finish in a day.

What this job involves

Gutters collect the water your roof sheds and send it somewhere harmless. When they fail, that water pours behind the fascia, runs down siding or soaks the soil next to the foundation. In Sacramento, the rain comes in fewer, heavier events, so a gutter that is slightly undersized or pitched wrong can overflow badly during a storm.

We install aluminum gutters formed on site so runs have no seams except at corners. We also repair sagging sections, replace rotted fascia, reset hangers and add downspouts. Because we work on roofs every day, we pay attention to how the gutter meets the roof edge, drip edge and flat-roof scuppers, and to whether the roof itself is throwing more water than the gutters can handle.

Warning signs

Signs your gutters need work

1Water overflowing in storms

Water pouring over the front edge in moderate rain means clogs, too little downspout capacity or a pitch that is holding water instead of moving it.

2Pulling away from the fascia

A visible gap between gutter and board, or a sagging middle, means the hangers or spikes have loosened or the fascia behind them is rotted.

3Rust or pinhole leaks

Older galvanized gutters rust at the seams and bottoms. Streaks below a seam and rusty drips after rain mean the gutter is nearing the end.

4Peeling paint under the eave

Paint bubbling on fascia and soffit shows water has been running behind or over the gutter for a while.

5Puddles near the foundation

Water pooling next to the house, or splash marks on the lower wall, suggests downspouts discharge too close or are blocked underground.

6Plants growing in gutters

Seedlings and moss in a gutter mean debris has built up into soil, which holds water and adds weight that bends the hangers.

K-style or half-round: choosing the profile

K-style gutters have a flat back and a decorative front that looks like crown molding. They hold more water for their width than half-round and are the standard on most Sacramento homes. Half-round gutters have a clean tube shape that suits older, craftsman and some mid-century houses, and they self-clean better, but they usually cost more and carry less water at the same size.

Common sizes are 5-inch and 6-inch. A 5-inch gutter works on small, simple roofs, while larger or steeper roofs and long valleys often call for 6-inch.

  • 5-inch K-style: typical home
  • 6-inch K-style: larger or steeper roofs
  • Half-round: older and custom homes
  • Aluminum: lightweight and rust-free
  • Copper and steel: specialty options
A downspout outlet with an elbow and splash extension beside a hidden hanger inside a white aluminum gutter
A downspout outlet with an elbow and splash extension beside a hidden hanger inside a white aluminum gutter.

Downspout sizing and placement

Downspouts are where gutters actually move water. The common sizes are 2x3 and 3x4 inches, with the bigger one carrying roughly double the flow. As a general rule of thumb, we plan about one downspout per 30 to 40 feet of gutter, and add more at valleys and where two roof planes meet.

Discharge matters as much as size. We extend outlets away from the foundation with splash blocks, extensions or tie-ins to drain pipes, and avoid dumping water on walkways or a neighbor's fence line.

Fascia, pitch and attachment

A gutter hung on rotted fascia will fail in a season. We probe fascia and replace soft sections first. Then we set the gutter with a slight slope, usually about 1/16 to 1/8 inch per foot toward each downspout, and attach with hidden hangers about every two feet, closer in areas with heavy snow or ladder use.

Drip edge goes under the starter shingle and over the gutter back so water does not wick behind. On flat roofs, we coordinate scuppers and conductor heads with the roof system so water leaves the surface cleanly.

How the job runs

Our process for gutter installation & repair

Six steps, in the order the crew does them on a Sacramento roof.

  1. Step 1Measure and assess

    We measure each run, note valleys and roof planes, check fascia condition and mark downspout locations and discharge points.

  2. Step 2Remove old gutters

    Old sections come off, hangers are pulled, and debris is cleaned from the edge so we can see the fascia and drip edge clearly.

  3. Step 3Repair the fascia

    Rotted boards are cut out and replaced, drip edge is corrected, and the edge is primed so the new gutter has solid backing.

  4. Step 4Form and hang the gutter

    Continuous aluminum is rolled to length, cut and mitered at corners, then hung with hidden hangers at the correct slope.

  5. Step 5Install downspouts

    Outlets, elbows and downspouts are fastened, extended away from the foundation, and tied into drains where one exists.

  6. Step 6Water test and clean up

    We run water through the system, check for leaks at the seams and end caps, and clear all debris from the work area.

Cost

What gutter installation & repair costs in Sacramento

MS-210 Gutter Installation & Repair2026 range
$8.40 to $19.80per linear ft

A single-story home with 150 linear feet of 5-inch K-style gutters and four downspouts typically costs around 1,640 to 2,730 installed.

What moves the price
  • Gutter size and profile
  • Single or two-story height
  • Fascia repair needed
  • Downspout count and extensions

Compare this job with others in the Sacramento roofing cost guide.

Sacramento conditions that matter

Sacramento's rain is concentrated from November through March, and a single atmospheric river storm can drop a lot of water in a day. Gutters need to be sized for those bursts. Valley oaks, liquidambars and pines drop leaves and needles that clog systems, so fall cleaning matters. Summer heat makes old sealant at gutter seams dry out and open. Many older homes have no gutters at all, and adding them can reduce splash staining and protect foundations in the clay soil common around the valley. Flat commercial roofs depend on scuppers and downspouts to avoid ponding.

FAQ

Questions about gutter installation & repair

What size gutter do I need for a typical Sacramento house?

Most single-story homes work well with 5-inch K-style gutters. Larger roofs, steep pitches or long valleys that funnel water into one spot often need 6-inch gutters and 3x4 downspouts. We size by roof area and rainfall intensity, not by what happens to be on the truck.

Are half-round gutters worth the extra cost?

They suit older and craftsman-style homes visually and shed leaves a bit better. The trade-off is lower capacity than K-style at the same width and a higher price. For most homes, K-style is the practical choice, and half-round is a style decision.

Can you fix a sagging gutter without replacing it?

Often yes. If the gutter is straight and not corroded, we reset it with new hidden hangers, fix the pitch and replace any rotted fascia behind it. If the metal is bent, rusted through or full of patches, replacing the run is the better value.

Why does my gutter overflow even when it is clean?

Common causes are an undersized gutter, too few downspouts, incorrect pitch or a roof valley that pours water past the gutter's front edge. A kickout or diverter at a valley end, plus a larger downspout, often solves it without new gutters.

Do gutters help a roof last longer?

They protect the edge. Without them, runoff soaks fascia and splashes siding and foundations. With them in good repair, the roof edge, drip edge and fascia stay drier. Gutters do not extend the life of the roof surface itself, but they prevent related rot.

Roof leaking, peeling or baking in the sun?

Call the 24/7 line. Tell us the roof type, where the water shows up or what the coating looks like, and we will tell you what we would check first and when a crew can be there.

Call (916) 963-8097
Call 24/7 (916) 963-8097