Skip to content
MountainsideFoam & Coating, Sacramento24/7 roof line(916) 963-8097

Roof coating coverage calculator

Turn roof area, coating type and target thickness into wet mils, gallons and 5-gallon pails.

Roof coating pails ready on a flat roof
Calculator

Enter your roof

Defaults show a typical 1,800 sq ft foam recoat with silicone.

Target dry film

Your rough numbers

Wet film needed21.7 mils
Coating with 10% waste27 gal
5-gallon pails6
Spread rate74 sq ft/gal

The math: wet mils = dry mils divided by solids by volume, and one gallon covers 1,604 sq ft at 1 wet mil. Manufacturer specs, primers, base coats and rough foam change the real order.

Want it measured on the roof instead? Call (916) 963-8097 and we will check thickness, adhesion and texture before we price it.

How to use the numbers

Start with the roof area from a plan, an aerial measurement or a tape. Pick the coating family and the dry film you want; 15 to 20 dry mils is common on a foam recoat in good condition, while 30 or more is typical on a first coat over new foam or on a roof with ponding areas.

The result includes 10 percent for waste, overspray and detail work. If the foam is rough, the texture setting adds more, because peaks and valleys each need the full thickness. Primers and base coats are separate products and are not included here.

  • Silicone: high solids, handles ponding, usually one or two coats
  • Acrylic: lower solids, more wet film for the same dry mils, two coats common
  • Polyurethane: tough base coat, often topped with an aliphatic or silicone layer
  • Every product: follow the data sheet, it beats any calculator
FAQ

Coating math questions

What is the difference between wet mils and dry mils?

Wet mils is the thickness of coating right after it goes on. Dry mils is what is left after the water or solvent leaves. A coating with 58 percent solids by volume that goes on at 34 wet mils dries to about 20 mils. Warranties and specs are written in dry mils, so that is the number to ask about.

Why does rough foam take so much more coating?

A coarse orange peel or popcorn foam surface has far more surface area than a smooth one, and every bump needs the full thickness of coating on its peaks and valleys. That is why texture changes the order more than almost anything else, and why sprayers try to keep foam at a smooth to orange peel finish.

Is the calculator enough to order coating myself?

Use it to sanity-check a bid or plan a budget. A real order also depends on the manufacturer's data sheet, primer or base coat requirements, detail work at curbs and walls, and how much coating the old surface soaks up. On a recoat, an adhesion test tells you whether the roof needs a primer at all.

Roof leaking, peeling or baking in the sun?

Call the 24/7 line. Tell us the roof type, where the water shows up or what the coating looks like, and we will tell you what we would check first and when a crew can be there.

Call (916) 963-8097
Call 24/7 (916) 963-8097